Manual

Chapter 29: RADIUS and TACACS+ Authentication Protocols
Section VII: Management Security 562
d. From the Authentication Menu, type 1 to select Server-based
Authentication. The following prompt is displayed:
Server Based User Authentication (E-Enabled, D-
Disabled) ->
e. Type E to enable server-based authentication on the switch.
f. After making changes, type R until you return to the Main Menu.
Then type S to select Save Configuration Changes.
Displaying
RADIUS Status
and Settings
The RADIUS Client Configuration menu shown in Figure 183 on page
560 has a selection that displays the RADIUS client software settings. The
selection, 6 - Show Status, displays the Show Status menu, as shown in
Figure 185
Figure 185 Show Status Menu
The information in this menu is for viewing purposes only. Most of the
columns are self-explanatory, with the possible exceptions of “Auth Req”
and “Auth Resp.” The “Auth Req” column displays the number of
authentication requests the switch has made to the RADIUS server. The
“Auth Resp” is the number of responses that the switch has received
back from the server.
Allied Telesyn Ethernet Switch AT-8524M - AT-S62
Production Server
User: Manager 11:20:02 02-Jan-2004
Show Status
Global Configuration
--------------------
Encryption Key : ATI
Server Timeout : 30 second(s)
Server IP Address Auth Port Encryption Key Auth Req Auth Resp
-----------------------------------------------------------------
149.11.11.11 1812 WRRT 100 96
149.22.22.22 1812 LLST 4 4
149.22.22.22 1812 OORT 0 0
U - Update Display
R - Return to Previous Menu
Enter your selection?