Manual

Chapter 4: Basic Switch Parameters
Section I: Basic Operations 76
Returning the AT-S62 Software to the Factory Default Values
The procedure in this section returns all AT-S62 software parameters,
including IP address and subnet mask, if assigned, to the default values.
Please note the following before performing this procedure:
❑ Returning all parameter settings to their default values also
deletes any port-based or tagged VLANs you created on the
switch.
❑ This procedure does not delete files from the AT-S62 file system.
To delete files, refer to Chapter 11, File System on page 146.
❑ This procedure does not delete any encryption keys stored in the
key database. To delete encryption keys, refer to Deleting an
Encryption Key on page 504.
❑ Returning a switch to its default values does not alter the contents
of the active boot configuration file. To reset the file back to the
default settings, you must must reestablished your management
session after the switch reboots and select Save Configuration
Changes. Otherwise the switch will revert back to the previous
configuration the next time you reset the unit.
The AT-S62 software default values can be found in Appendix A,
AT-S62 Default Settings on page 820.
Caution
This procedure results in a switch reset. The switch will not forward
traffic while it initializes its operating software, a process that takes
approximately 20 seconds to complete. Some packet traffic may be
lost.
To return the AT-S62 software to the default settings, perform the
following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 7 on page 59.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 9 on page 64.
3. For the System Utilities menu, type 4 to select Reset to Factory
Defaults.