Owner manual

157
Chapter 8
Port Parameter Commands
This chapter contains the following commands:
❑ ACTIVATE SWITCH PORT on page 158
❑ DISABLE INTERFACE LINKTRAP on page 159
❑ DISABLE SWITCH PORT on page 160
❑ DISABLE SWITCH PORT FLOW on page 161
❑ ENABLE INTERFACE LINKTRAP on page 162
❑ ENABLE SWITCH PORT on page 163
❑ ENABLE SWITCH PORT FLOW on page 164
❑ RESET SWITCH PORT on page 165
❑ SET SWITCH PORT on page 166
❑ SET SWITCH PORT RATELIMIT on page 171
❑ SHOW INTERFACE on page 174
❑ SHOW SWITCH PORT on page 176
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
Refer to the AT-S62 Management Software Menus Interface User’s
Guide for background information on the port parameters.