User Manual
Table Of Contents
- Contents
- Figures
- Preface
- Section I
- Basic Operations
- Chapter 1
- Starting a Web Browser Management Session
- Chapter 2
- Basic Switch Parameters
- Chapter 3
- Enhanced Stacking
- Chapter 4
- SNMPv1 and SNMPv2c Community Strings
- Chapter 5
- Port Parameters
- Chapter 6
- MAC Address Table
- Chapter 7
- Static Port Trunks
- Chapter 8
- Port Mirroring
- Section II
- Advanced Operations
- Chapter 9
- File System
- Chapter 10
- File Downloads and Uploads
- Chapter 11
- Event Log and Syslog Servers
- Chapter 12
- Classifiers
- Chapter 13
- Access Control Lists
- Chapter 14
- Quality of Service
- Chapter 15
- Class of Service
- Chapter 16
- IGMP Snooping
- Chapter 17
- Denial of Service Defense
- Chapter 18
- Power Over Ethernet
- Section III
- SNMPv3 Operations
- Chapter 19
- SNMPv3
- Enabling the SNMP Protocol
- Configuring the SNMPv3 User Table
- Configuring the SNMPv3 View Table
- Configuring the SNMPv3 Access Table
- Configuring the SNMPv3 SecurityToGroup Table
- Configuring the SNMPv3 Notify Table
- Configuring the SNMPv3 Target Address Table
- Configuring the SNMPv3 Target Parameters Table
- Configuring the SNMPv3 Community Table
- Displaying SNMPv3 Tables
- Section IV
- Spanning Tree Protocols
- Chapter 20
- Spanning Tree, Rapid Spanning Tree, and Multiple Spanning Tree Protocols
- Section V
- Virtual LANs
- Chapter 21
- Port-based and Tagged Virtual LANs
- Chapter 22
- GARP VLAN Registration Protocol
- Chapter 23
- Protected Ports VLANs
- Section VI
- Port Security
- Chapter 24
- MAC Address-based Port Security
- Chapter 25
- 802.1x Port-based Network Access Control
- Section VII
- Management Security
- Chapter 26
- Encryption Keys, PKI, and SSL
- Chapter 27
- Secure Shell Protocol
- Chapter 28
- TACACS+ and RADIUS Authentication Protocols
- Chapter 29
- Management Access Control List
- Index
AT-S62 Management Software Web Browser Interface User’s Guide
Section II: Advanced Operations 177
The CoS Setting for Port page is shown in Figure 50.
Figure 50. CoS Setting for Port Page
6. Use the Priority list to select a new Class of Service priority level for the
port. The default is level 0. The new priority level will apply to all
ingress untagged packets. (If you perform Step 7 and override the
priority level in tagged packets, the new priority level will also apply to
all ingress tagged packets.)
7. If you are configuring a tagged port and you want the port to ignore the
priority tag in the packets, click the Override Priority option. A check
in the box indicates this feature is activated. All tagged packets are
directed to the egress queue specified in Step 4.
Note
The switch does not change the tagged information in a tagged
packet. A tagged packet exits the switch with the same priority level
that it had when it entered.
The default for this parameter is No, meaning that the priority level of a
tagged packet is determined by the tagged information in the packet
itself.
8. Click Apply. Configuration changes are immediately activated on the
switch.
9. To permanently save the change, click the Save Config menu option.