User Manual
Table Of Contents
- Contents
- Figures
- Preface
- Section I
- Basic Operations
- Chapter 1
- Starting a Web Browser Management Session
- Chapter 2
- Basic Switch Parameters
- Chapter 3
- Enhanced Stacking
- Chapter 4
- SNMPv1 and SNMPv2c Community Strings
- Chapter 5
- Port Parameters
- Chapter 6
- MAC Address Table
- Chapter 7
- Static Port Trunks
- Chapter 8
- Port Mirroring
- Section II
- Advanced Operations
- Chapter 9
- File System
- Chapter 10
- File Downloads and Uploads
- Chapter 11
- Event Log and Syslog Servers
- Chapter 12
- Classifiers
- Chapter 13
- Access Control Lists
- Chapter 14
- Quality of Service
- Chapter 15
- Class of Service
- Chapter 16
- IGMP Snooping
- Chapter 17
- Denial of Service Defense
- Chapter 18
- Power Over Ethernet
- Section III
- SNMPv3 Operations
- Chapter 19
- SNMPv3
- Enabling the SNMP Protocol
- Configuring the SNMPv3 User Table
- Configuring the SNMPv3 View Table
- Configuring the SNMPv3 Access Table
- Configuring the SNMPv3 SecurityToGroup Table
- Configuring the SNMPv3 Notify Table
- Configuring the SNMPv3 Target Address Table
- Configuring the SNMPv3 Target Parameters Table
- Configuring the SNMPv3 Community Table
- Displaying SNMPv3 Tables
- Section IV
- Spanning Tree Protocols
- Chapter 20
- Spanning Tree, Rapid Spanning Tree, and Multiple Spanning Tree Protocols
- Section V
- Virtual LANs
- Chapter 21
- Port-based and Tagged Virtual LANs
- Chapter 22
- GARP VLAN Registration Protocol
- Chapter 23
- Protected Ports VLANs
- Section VI
- Port Security
- Chapter 24
- MAC Address-based Port Security
- Chapter 25
- 802.1x Port-based Network Access Control
- Section VII
- Management Security
- Chapter 26
- Encryption Keys, PKI, and SSL
- Chapter 27
- Secure Shell Protocol
- Chapter 28
- TACACS+ and RADIUS Authentication Protocols
- Chapter 29
- Management Access Control List
- Index
AT-S62 Management Software Web Browser Interface User’s Guide
Section VI: Port Security 339
server. This parameter only applies when the port is operating in the
Multiple operating mode. Possible settings are:
On: Specifies that only those supplicants with the same VLAN
assignment as the initial supplicant are authenticated. Supplicants
with a different or no VLAN assignment are denied entry to the
port. This is the default setting.
Off: Specifies that all supplicants, regardless of their assigned
VLANs, are authenticated. However, the port remains in the VLAN
specified in the initial authentication, regardless of the VLAN
assignments of subsequent authentications.
Guest VLAN
This parameter specifies the VID of a Guest VLAN. The authenticator
port is a member of a Guest VLAN when no supplicant is logged on.
Clients do not log on to access a Guest VLAN. You can specify a
Guest VLAN by either its name or VID. To remove a Guest VLAN
without assigning a new one, delete the name or VID of the assigned
VLAN.
4. Click Apply.
Changes to the authenticator settings are immediately implemented on
a port.
5. To permanently save the changes, select the Save Config menu
selection.