User guide

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 201
SHOW SWITCH FDB
Syntax
show switch fdb [macaddress|destaddress= macaddress ]
[port= port ] [type|status=static|staticunicast|
staticmulticast|dynamic|dynamicunicast|dynamicmulticast]
[vlan=
name ] [module= value ]
Parameters
address Specifies a MAC address. Use this parameter to determine
the port on the switch on which a particular MAC address
was learned (dynamic) or assigned (static). The address can
be entered in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
port Specifies a port on the switch. Use this parameter to view all
addresses learned on a particular port. You can specify more
than one port.
type or Displays specific types of MAC addresses. Options are:
status
static Displays all static unicast and multicast
MAC addresses.
staticunicast Displays all static unicast addresses.
staticmulticast Displays all static multicast addresses.
dynamic Displays all dynamic unicast and
multicast MAC addresses.
dynamicunicast Displays all dynamic unicast addresses.
dynamicmulticast Displays all dynamic multicast
addresses.
vlan Specifies a VLAN name. Use this parameter to view the MAC
addresses learned or assigned to the ports of a particular
VLAN on the switch.
module Specifies the stack ID number of a switch in an AT-9400
Stack. Use this parameter to view the MAC address table of a
member switch in a stack. All the MAC address tables of the
switches in the stack are the same, but you can use this
option to view addresses that member switches haven’t yet
shared with the other units. To view the stack ID numbers,
use “SHOW STACK” on page 106.
Command
Available
AlliedWare Plus