User guide

AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing 711
ADD IP RIP
Syntax
add ip rip interface= interface [send=rip1|rip2]
[receive=rip1|rip2|both] [authentication=pass|none]
[password=
password ]
[poisonreverse=yes|no|on|off|true|false]
[autosummary=yes|no|on|off|true|false]
Parameters
interface Specifies the name of the routing interface where RIP
is to be added. An interface name consists of “VLAN”
followed by the name or ID (VID) of the VLAN and the
interface number (e.g., vlan-Sales-0 or vlan4-0).
send Specifies the version of RIP packets to be sent by the
routing protocol. Options are:
rip1 Sends RIP version 1 packets. This is the
default value.
rip2 Sends RIP version 2 packets.
receive Specifies the version of RIP packets to be accepted
by the routing protocol. Options are:
rip1 Accepts RIP version 1 packets.
rip2 Accepts RIP version 2 packets.
both Accepts RIP version 1 and 2 packets.
This is the default value.
authentication Specifies whether there is password protection. This
option only applies to RIP version 2. Options are:
pass Specifies password protection. The
password is assigned with the
PASSWORD parameter.
none Specifies no password protection. This is
the default setting.
password Specifies the password used to authenticate RIP
version 2 packets. The password can be up to sixteen
alphanumeric characters. The password is case
sensitive and can include the hyphen and underscore.
Command
Available
AlliedWare Plus