Owner's manual

175
Chapter 11
LACP Port Trunking Commands
This chapter contains the following commands:
 “ADD LACP PORT” on page 176
 “CREATE LACP AGGREGATOR” on page 178
 “DELETE LACP PORT” on page 180
 “DESTROY LACP AGGREGATOR” on page 181
 “DISABLE LACP” on page 182
 “ENABLE LACP” on page 183
 “SET LACP AGGREGATOR” on page 184
 “SET LACP SYSPRIORITY” on page 186
 “SET LACP STATE” on page 187
 “SHOW LACP” on page 188
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For overview information on this feature, refer to the AT-S63
Management Software Features Guide.