Owner's manual

Chapter 11: LACP Port Trunking Commands

184 Section I: Basic Operations

SET LACP AGGREGATOR

Syntax

set lacp aggregator=

name

|adminkey=

key

Parameters

aggregator Specifies the name of the aggregator you want to

modify. The name is case-sensitive.

adminkey Specifies the adminkey number of the aggregator you

want to modify. This is a hexadecimal number between

0x1 and 0xffff.

distribution Specifies one of the following load distribution methods:

macsrc Source MAC address.

macdest Destination MAC address.

macboth Source address/destination MAC

address. This is the default.

ipsrc Source IP address.

ipdest Destination IP address.

ipboth Source address/destination IP

address.

Description

This command modifies the load distribution method of an existing LACP

aggregator. You can identify the aggregator by its name or adminkey. To

display the names and adminkeys of the aggregators on the switch, refer

to “SHOW LACP” on page 188.

Note

You cannot change the name or adminkey of an existing aggregator.

Examples

The following command changes the load distribution method of an LACP

aggregator titled “agg_5” to the source MAC address method:

set lacp aggregator=agg_5 distribution=macsrc