User guide

Chapter 17: SNMPv3
222 Section III: SNMPv3
Configuring the SNMPv3 Access Table
You can create, delete, and modify an SNMPv3 Access Table entry. See
the following procedures:
 “Creating an Access Table” on page 222
 “Deleting an Access Table Entry” on page 225
 “Modifying an Access Table Entry” on page 226
For information about the SNMPv3 Access Table, see Chapter 21,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating an
Access Table
To create an entry in the SNMPv3 Access Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 1 on page 28.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 206.
3. In the SNMPv3 section, click the button next to Configure Access
Table and then click Configure at the bottom of the tab.
The SNMPv3 Access Table tab is shown in Figure 82.
Figure 82. SNMPv3 Access Table Tab (Configuration)