User guide

Chapter 17: SNMPv3
238 Section III: SNMPv3
4. Click the button next to the Notify Table entry to be deleted, and then
click Remove.
A warning message is displayed.
5. Click OK.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.
Modifying a
Notify Table
Entry
To modify an entry in the SNMPv3 Notify Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 1 on page 28.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 75 on page 206.
3. In the SNMPv3 section, click the button next to Configure Notify Table,
and then click Configure at the bottom of the tab.
The SNMPv3 Notify Table tab is shown in Figure 88 on page 236.
4. Click the button next to the table entry to be changed and then click
Modify.
The Modify SNMPv3 Notify page is shown in Figure 90.
Figure 90. Modify SNMPv3 Notify Page
5. In the Notify Tag field, enter a description name of the Notify Tag.
Enter a name of up to 32 alphanumeric characters.