User guide

AT-S63 Management Software Web Browser User’s Guide
Section I: Basic Operations 29
Note
This procedure describes the System Name, Administrator, and
Comments parameters in the Administration section of the tab. The
parameters in the IP Configuration section are described in
“Displaying the IP Address of the Local Interface” on page 39. The
Passwords section is described in “Changing the Manager and
Operator Passwords” on page 30. The Reset button at the bottom of
the tab resets the switch and is explained in “Rebooting a Switch” on
page 35.
2. Configure the following parameters as necessary:
System Name
This parameter specifies a name for the switch (for example, Sales
Ethernet switch). The name is displayed at the top of the AT-S63
management pages and tabs. The name can be from 1 to 39
characters. The name can include spaces and special characters,
such as exclamation points and asterisks. The default is no name. This
parameter is optional.
Administrator
This parameter specifies the name of the network administrator
responsible for managing the switch. The name can be from 1 to 20
characters. It can include spaces and special characters, such as
dashes and asterisks. The default is no name. This parameter is
optional.
Comments
This parameter specifies the location of the switch, (for example, 4th
Floor - rm 402B). The location can be from 1 to 20 characters. The
location can include spaces and special characters, such as dashes
and asterisks. The default is no location. This parameter is optional.
3. Click Apply to activate your changes on the switch.
4. To permanently save your changes, select the Save Config option in
the Configuration menu.