Manual

Chapter 32: Internet Protocol Version 4 Packet Routing Commands
580 Section VII: Internet Protocol Routing
SHOW IP RIP INTERFACE
Syntax
show ip rip interface[= interface ]
Parameters
interface Specifies the interface name. An interface name
consists of “VLAN” and the ID (VID) followed by the
VLAN name or interface number, separated by a
dash (e.g., vlan4-Sales or vlan4-0). If no interface
value is specified, the switch displays all the
interfaces with the routing protocol.
Description
This command lists the RIP settings on those routing interfaces that have
RIP. An example of the information displayed by this command is shown
in Figure 51.
Figure 51. SHOW IP RIP Command
The columns in the display are described here:
 Interface - An interface name consisting of a VLAN’s identification
(VID) number and interface number.
 Send - The version of RIP packets sent by the interface. Possible
settings are:
– RIP1: version 1 packets
– RIP2: version 2 packets
 Receive - The version of RIP packets the interface will accept.
Possible settings are:
– RIP1: version 1 packets
– RIP2: version 2 packets
– BOTH: both version 1 and 2 packets
----------------------------------------------------------------------------
Interface Send Recv Auth Password PoisonReverse AutoSummary
----------------------------------------------------------------------------
vlan2-0 RIP2 BOTH PASS ******** On On
vlan5-0 RIP1 BOTH NONE NOT SET Off On
vlan8-0 RIP2 BOTH PASS ******** Off Off
vlan8-1 RIP2 BOTH PASS ******** On On