Owner manual

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 161
SET SWITCH AGINGTIMER|AGEINGTIMER
Syntax
set switch agingtimer|ageingtimer= value
Parameter
agingtimer or Specifies the aging timer for the MAC address table.
ageingtimer The value is in seconds. The range is 0 to 1048575.
The default is 300 seconds (5 minutes). The
parameters are equivalent.
Description
The switch uses the aging timer to delete inactive dynamic MAC
addresses from the MAC address table. When the switch detects that no
packets have been sent to or received from a particular MAC address in
the table after the period specified by the aging time, the switch deletes the
address. This prevents the table from becoming full of addresses of nodes
that are no longer active.
Setting the aging timer to 0 disables the timer. No dynamic MAC
addresses are aged out and the table stops learning new addresses after
reaching maximum capacity.
To view the current setting for the MAC address aging timer, refer to
“SHOW SWITCH AGINGTIMER|AGEINGTIMER” on page 162.
Example
The following command sets the aging timer to 120 seconds (2 minutes):
set switch agingtimer=120