Owner manual

Chapter 16: Event Log and Syslog Server Commands
262 Section II: Advanced Operations
SAVE LOG
Syntax
save log[=permanent|temporary] filename= filename .log [full]
[module=
module ] [reverse] [severity=all| severity ]
[overwrite]
Parameters
log Specifies the source of the events you want to save
to the log file. The options are:
permanent Permanent (nonvolatile) memory.
Saves events stored in nonvolatile
memory, which can contain up to
2,000 events.
temporary Temporary memory. Saves events
stored in temporary memory, which
can contain up to 4,000 events. This is
the default.
filename Specifies the filename for the log. The name can be
up to 16 alphanumeric characters, followed by the
extension ”.log.” Spaces are allowed. The filename
must be enclosed in quotes if it contains spaces.
Otherwise, the quotes are optional.
full Specifies the amount of information saved to the log.
Without this option, the log saves only the time,
module, severity, and description for each entry. With
it, the log also saves the filename, line number, and
event ID.
module Specifies the AT-S63 module whose events are to be
saved. For a list of modules, refer to Table 9 on
page 269. Omitting this parameter saves the events
from all the modules.
reverse Specifies the order of the events in the log. Without
this option, the events are saved oldest to newest.
With this option, the events are saved newest to
oldest.
severity Specifies the severity of events to be saved. The
options are:
all Saves events of all severity levels.