Owner manual

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 77
 VLAN mode - The switch’s VLAN mode. The three possible VLAN
modes are:
 User configured (for creating your own port-based and tagged
VLANs)
 802.1Q-compliant
 Non-802.1Q-compliant.
The default is user configured. To set a switch’s VLAN mode, refer to
“SET SWITCH VLANMODE” on page 526.
 Management VLAN - The ID number of the management VLAN. The
switch uses the management VLAN for remote Telnet, SSH, and web
browser management sessions. The default is 1, which is the ID
number for the Default_VLAN. To set the management VLAN, refer to
“SET SWITCH MANAGEMENTVLAN” on page 525.
 Ingress filtering - The status of ingress filtering on the switch. When
ingress filtering is activated, tagged frames are filtered when they are
received on a port. When ingress filtering is deactivated, which is the
default, tagged frames are filtered before they are transmitted out a
port. To set ingress filtering, refer to “SET SWITCH INFILTERING” on
page 524.
 Active Spanning Tree version - The spanning tree protocol that has
been designated as the active protocol on the switch. To configure or
enable a spanning tree protocol, you must first designate it as the
active protocol on the switch. The switch supports, STP, RSTP, and
MSTP. The default is RSTP. To select an active spanning tree protocol,
refer to “ACTIVATE STP” on page 462, “ACTIVATE RSTP” on
page 476, and “ACTIVATE MSTP” on page 490.
 Mirroring state - The status of port mirroring. The display includes the
destination port as well as the ingress and egress source ports if port
mirroring is activated on the switch. To configure port mirroring, refer to
“SET SWITCH MIRROR” on page 194 and “SET SWITCH PORT
MIRROR” on page 195.
 Enhanced stacking mode - The enhanced stacking mode of the switch,
which can be master, slave, or unavailable. The default is slave. To set
the enhanced stacking status, refer to “SET SWITCH STACKMODE”
on page 84.
 Console disconnect timer interval - The current value of the console
timer, used by the management software to end inactive management
sessions. The AT-S63 software ends a local or remote management
session if it does not detect any management activity for the length of
time specified by the console timer. The default is 10 minutes. To set
the console timer, refer to “SET SWITCH CONSOLETIMER” on
page 63.
 Web server status - The status of the web server. When the web server
is disabled, you cannot remotely manage the switch using a web
browser and the web browser interface. The default setting is enabled.