Manual

Chapter 18: SNMPv3
234 Section III: SNMPv3
Configuring the SNMPv3 View Table
You can create, delete, and modify an SNMPv3 View Table entry. See the
following procedures:
 “Creating a View Table Entry” on page 234
 “Deleting a View Table Entry” on page 237
 “Modifying a View Table Entry” on page 237
For reference information about the SNMPv3 View Table, see Chapter 21,
“SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating a View
Table Entry
To create an entry in the SNMPv3 View Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 44.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 79 on page 224.
3. In the SNMPv3 section, click the button next to Configure View Table
and then click Configure at the bottom of the tab.