Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Section I
- Basic Operations
- Chapter 1
- Starting a Web Browser Management Session
- Chapter 2
- Basic Switch Parameters
- Configuring the Switch’s Name, Location, and Contact
- Changing the Manager and Operator Passwords
- Setting the System Date and Time
- Rebooting a Switch
- Pinging a Remote System
- Returning the AT-S63 Management Software to the Factory Default Values
- Displaying the IP Address of the Local Interface
- Displaying System Information
- Chapter 3
- Enhanced Stacking
- Chapter 4
- SNMPv1 and SNMPv2c
- Chapter 5
- Port Parameters
- Chapter 6
- MAC Address Table
- Chapter 7
- Static Port Trunks
- Chapter 8
- Port Mirroring
- Section II
- Advanced Operations
- Chapter 9
- File System
- Chapter 10
- File Downloads and Uploads
- Chapter 11
- Event Logs and Syslog Servers
- Chapter 12
- Classifiers
- Chapter 13
- Access Control Lists
- Chapter 14
- Class of Service
- Chapter 15
- Quality of Service
- Chapter 16
- Denial of Service Defense
- Chapter 17
- IGMP Snooping
- Section III
- SNMPv3
- Chapter 18
- SNMPv3
- Configuring the SNMPv3 Protocol
- Enabling or Disabling SNMP Management
- Configuring the SNMPv3 User Table
- Configuring the SNMPv3 View Table
- Configuring the SNMPv3 Access Table
- Configuring the SNMPv3 SecurityToGroup Table
- Configuring the SNMPv3 Notify Table
- Configuring the SNMPv3 Target Address Table
- Configuring the SNMPv3 Target Parameters Table
- Configuring the SNMPv3 Community Table
- Displaying SNMPv3 Tables
- Section IV
- Spanning Tree Protocols
- Chapter 19
- Spanning Tree and Rapid Spanning Tree Protocols
- Chapter 20
- Multiple Spanning Tree Protocol
- Section V
- Virtual LANs
- Chapter 21
- Port-based and Tagged VLANs
- Chapter 22
- GARP VLAN Registration Protocol
- Section VI
- Port Security
- Chapter 23
- MAC Address-based Port Security
- Chapter 24
- 802.1x Port-based Network Access Control
- Section VII
- Management Security
- Chapter 25
- Encryption Keys, PKI, and SSL
- Chapter 26
- Secure Shell (SSH)
- Chapter 27
- TACACS+ and RADIUS Protocols
- Chapter 28
- Management Access Control List
- Index
AT-S63 Management Software Web Browser Interface User’s Guide
Section VII: Management Security 419
The tab is shown in Figure 168.
Figure 168. Mgmt. ACL Tab (Configuration)
The table in Management ACL List lists the existing ACEs on the
switch. The bottom portion is used to add entries, as explained in
“Creating an ACE” on page 420.
4. Click either Enable MGMT. ACL or Disable MGMT. ACL. The default
setting is disabled.
5. Click Apply.
A change to the status of the management ACL is immediately
activated on the switch.
Note
If you activate the feature before entering an access control entry
that specifies your management workstation, either by its IP address
or subnet, your web browser management session will end and you
will not be able to reestablish it.
6. To permanently save your changes, select the Save Config option in
the Configuration menu.