Owner manual

Chapter 6: Port Parameter Commands
106 Section I: Basic Operations
PURGE SWITCH PORT
Syntax
purge switch port=
port
Parameters
port Specifies the port whose parameter settings are to be
returned to the default values. You can specify more
than one port at a time. Port numbers are specified in
the following format:
module ID.port number
For instructions, refer to “Port Numbers in
Commands” on page 40.
Description
This command returns all of the parameter settings of a port to the factory
default values. To reset a port and retain its settings, use “RESET
SWITCH PORT” on page 107.
Example
This example resets the settings for port 2.10 to the factory default values:
purge switch port=2.10