Instruction Manual

281
Chapter 16
Event Log and Syslog Client Commands
This chapter contains the following commands:
 “ADD LOG OUTPUT” on page 282
 “CREATE LOG OUTPUT” on page 284
 “DESTROY LOG OUTPUT” on page 288
 “DISABLE LOG” on page 289
 “DISABLE LOG OUTPUT” on page 290
 “ENABLE LOG” on page 291
 “ENABLE LOG OUTPUT” on page 292
 “PURGE LOG” on page 293
 “SAVE LOG” on page 294
 “SET LOG FULLACTION” on page 296
 “SET LOG OUTPUT” on page 297
 “SHOW LOG” on page 300
 “SHOW LOG OUTPUT” on page 305
 “SHOW LOG STATUS” on page 307
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Layer 2+ Models
AT-9408LC/SP
AT-9424T/GB
AT-9424T/SP
Basic Layer 3 Models
AT-9424T
AT-9424T/POE
AT-9424Ts
AT-9424Ts/XP
AT-9448T/SP
AT-9448Ts/XP
Stacks of Basic
Layer 3 Switches
Supported on:
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes