Instruction Manual

Chapter 23: Internet Group Management Protocol (IGMP) Snooping Commands
428 Section III: Snooping Protocols
SET IP IGMP
Syntax
set ip igmp [snoopingstatus=enabled|disabled]
[hoststatus=singlehost|multihost] [timeout=
value ]
[numbermulticastgroups=
value ]
[routerport=
port |all|none|auto]
Parameters
snoopingstatus Activates and deactivates IGMP snooping
on the switch. The options are:
enabled Activates IGMP snooping.
disabled Deactivates IGMP snooping.
This is the default setting.
hoststatus Specifies the IGMP host node topology.
Options are:
singlehost Activates the Single-Host/Port
setting, which is appropriate
when there is only one host
node connected to a port on
the switch. This is the default
setting.
multihost Activates the Multi-Host
setting, which is appropriate if
there is more than one host
node connected to a switch
port.
timeout Specifies the time period in seconds that is
used to identify inactive host nodes. Inactive
host nodes are nodes that do not sent IGMP
reports during the specified time interval.
The range is from 0 second to 86,400
seconds (24 hours). The default is 260
seconds. If you set the timeout to zero (0),
the timer never times out, and the timeout
interval is essentially disabled.
This parameter also controls the time
interval used by the switch in determining
whether a multicast router is still active. The
switch makes the determination by watching
for queries from the router. If the switch does
Command
Available
AlliedWare Plus