User Manual

Chapter 11: SNMPv3
142 Section III: SNMPv3
Deleting a View
Table Entry
To delete an entry from the SNMPv3 View Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure View
Table and then the Configure button to display the SNMPv3 View
Table tab in Figure 41 on page 139.
4. Click the radio button for the View Table entry you want to delete and
then click the Remove button.
5. At the confirmation prompt, click the OK button.
6. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Modifying a View
Table Entry
To modify an entry in the SNMPv3 View Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for Configure View
Table and the Configure button to display the SNMPv3 View Table
tab in Figure 41 on page 139.
4. Click the radio button of the SNMPv3 View Table entry you want to
change and then click the Modify button. An example of the Modify
SNMPv3 View page is shown in Figure 43.
Figure 43. Modify SNMPv3 View Page