User Manual

AT-S63 Management Software Web Browser User’s Guide
Section III: SNMPv3 153
6. To save your changes in the master configuration file, click the Save
Config button.
Modifying a
SecurityToGroup
Table Entry
To modify an entry in the SNMPv3 SecurityToGroup Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure
SecurityToGroup Table and then click the Configure button to
display the SNMPv3 SecurityToGroup Table tab, shown in Figure 47
on page 150.
4. Click the radio button of the SecurityToGroup Table entry you want to
change, and then click the Modify button to display the Modify
SNMPv3 SecurityToGroup window for the entry. An example of the
window is shown in Figure 49.
Figure 49. Modify SNMPv3 SecurityToGroup Window
5. Modify the parameters as needed. The parameters are described in
Table 25 on page 151.
6. After modifying the entry, click the Apply button.
7. At the confirmation prompt, click the OK button.
8. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.