User Manual

Chapter 11: SNMPv3
166 Section III: SNMPv3
Deleting a Target
Parameters Table
Entry
To delete an entry from the SNMPv3 Target Parameters Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for Configure Target
Parameters Table and then the Configure button to display the
SNMPv3 Target Parameters Table tab in Figure 56 on page 163.
4. Click the radio button of the Target Parameters Table entry you want
to delete and then the Remove button.
5. At the confirmation prompt, click the OK button.
6. To save your changes in the master configuration file, click the Save
Config button in the Configuration menu.
Modifying a
Target
Parameters Table
Entry
To modify an entry in the SNMPv3 Target Parameters Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for the Configure Target
Parameters Table and then click the Configure button to display the
SNMPv3 Target Parameters Table tab in Figure 56 on page 163.
4. Click the radio button of the Target Parameters Table entry that you
want to change, and then click the Modify button. An example of the
Modify SNMPv3 Target Parameter window is shown in Figure 58.
Figure 58. Modify SNMPv3 Target Parameter Window