User Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Section I
- Basic Operations
- Chapter 1
- Basic Switch Parameters
- Chapter 2
- Port Parameters
- Chapter 3
- SNMPv1 and SNMPv2c
- Chapter 4
- MAC Address Table
- Chapter 5
- Static Port Trunks
- Chapter 6
- Port Mirroring
- Section II
- Advanced Operations
- Chapter 7
- File System
- Chapter 8
- File Downloads and Uploads
- Chapter 9
- Event Logs and the Syslog Client
- Chapter 10
- IGMP Snooping
- Section III
- SNMPv3
- Chapter 11
- SNMPv3
- Configuring the SNMPv3 Protocol
- Enabling or Disabling SNMP Management
- Configuring the SNMPv3 User Table
- Configuring the SNMPv3 View Table
- Configuring the SNMPv3 Access Table
- Configuring the SNMPv3 SecurityToGroup Table
- Configuring the SNMPv3 Notify Table
- Configuring the SNMPv3 Target Address Table
- Configuring the SNMPv3 Target Parameters Table
- Configuring the SNMPv3 Community Table
- Displaying the SNMPv3 Tables
- Displaying the User Table Entries
- Displaying the View Table Entries
- Displaying the Access Table Entries
- Displaying the SecurityToGroup Table Entries
- Displaying the Notify Table Entries
- Displaying the Target Address Table Entries
- Displaying the Target Parameters Table Entries
- Displaying the SNMPv3 Community Table Entries
- Section IV
- Spanning Tree Protocols
- Chapter 12
- Spanning Tree and Rapid Spanning Tree Protocols
- Section V
- Virtual LANs
- Chapter 13
- Port-based and Tagged VLANs
- Section VI
- Port Security
- Chapter 14
- 802.1x Port-based Network Access Control
- Index
Chapter 11: SNMPv3
168 Section III: SNMPv3
Configuring the SNMPv3 Community Table
To create, delete, or modify SNMPv3 Community Table entries, refer to
the following procedures:
“Creating an SNMPv3 Community Table Entry” on page 168
“Deleting an SNMPv3 Community Table Entry” on page 170
“Modifying an SNMPv3 Community Table Entry” on page 170
Note
The SNMPv3 Community Table is used to configure the protocol for
use with SNMPv1 or SNMPv2c. Allied Telesis does not recommend
this configuration.
Creating an
SNMPv3
Community
Table Entry
To create an entry in the SNMPv3 Community Table:
1. From the Home page, click the Configuration button.
2. From the Configuration menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 11 on page 50.
3. In the SNMPv3 section, click the radio button for Configure
Community Table and then click the Configure button to display the
SNMPv3 Community Table tab, shown in Figure 59.
Figure 59. SNMPv3 Community Table Tab
4. Click the Add button to display the Add New SNMPv3 Community
page in Figure 60.