User Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Section I
- Basic Operations
- Chapter 1
- Basic Switch Parameters
- Chapter 2
- Port Parameters
- Chapter 3
- SNMPv1 and SNMPv2c
- Chapter 4
- MAC Address Table
- Chapter 5
- Static Port Trunks
- Chapter 6
- Port Mirroring
- Section II
- Advanced Operations
- Chapter 7
- File System
- Chapter 8
- File Downloads and Uploads
- Chapter 9
- Event Logs and the Syslog Client
- Chapter 10
- IGMP Snooping
- Section III
- SNMPv3
- Chapter 11
- SNMPv3
- Configuring the SNMPv3 Protocol
- Enabling or Disabling SNMP Management
- Configuring the SNMPv3 User Table
- Configuring the SNMPv3 View Table
- Configuring the SNMPv3 Access Table
- Configuring the SNMPv3 SecurityToGroup Table
- Configuring the SNMPv3 Notify Table
- Configuring the SNMPv3 Target Address Table
- Configuring the SNMPv3 Target Parameters Table
- Configuring the SNMPv3 Community Table
- Displaying the SNMPv3 Tables
- Displaying the User Table Entries
- Displaying the View Table Entries
- Displaying the Access Table Entries
- Displaying the SecurityToGroup Table Entries
- Displaying the Notify Table Entries
- Displaying the Target Address Table Entries
- Displaying the Target Parameters Table Entries
- Displaying the SNMPv3 Community Table Entries
- Section IV
- Spanning Tree Protocols
- Chapter 12
- Spanning Tree and Rapid Spanning Tree Protocols
- Section V
- Virtual LANs
- Chapter 13
- Port-based and Tagged VLANs
- Section VI
- Port Security
- Chapter 14
- 802.1x Port-based Network Access Control
- Index
Chapter 11: SNMPv3
172 Section III: SNMPv3
Displaying the SNMPv3 Tables
This section contains procedures to display the SNMPv3 Tables. The
following procedures are provided:
“Displaying the User Table Entries,” next
“Displaying the View Table Entries” on page 173
“Displaying the Access Table Entries” on page 174
“Displaying the SecurityToGroup Table Entries” on page 175
“Displaying the Notify Table Entries” on page 176
“Displaying the Target Address Table Entries” on page 177
“Displaying the Target Parameters Table Entries” on page 178
“Displaying the SNMPv3 Community Table Entries” on page 179
Displaying the
User Table
Entries
To display the entries in the SNMPv3 User Table:
1. From the Home page, click the Monitoring button.
2. From the Monitoring menu, click the Mgmt. Protocols button to
display the SNMP tab, shown in Figure 14 on page 58.
3. In the SNMPv3 section, click the radio button for View User Table and
the View button to display the SNMPv3 User Table tab in Figure 62.
The parameters that define the user table entries are described in
Table 22 on page 135.
Figure 62. SNMPv3 User Table Tab (Monitoring)