User Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Section I
- Basic Operations
- Chapter 1
- Basic Switch Parameters
- Chapter 2
- Port Parameters
- Chapter 3
- SNMPv1 and SNMPv2c
- Chapter 4
- MAC Address Table
- Chapter 5
- Static Port Trunks
- Chapter 6
- Port Mirroring
- Section II
- Advanced Operations
- Chapter 7
- File System
- Chapter 8
- File Downloads and Uploads
- Chapter 9
- Event Logs and the Syslog Client
- Chapter 10
- IGMP Snooping
- Section III
- SNMPv3
- Chapter 11
- SNMPv3
- Configuring the SNMPv3 Protocol
- Enabling or Disabling SNMP Management
- Configuring the SNMPv3 User Table
- Configuring the SNMPv3 View Table
- Configuring the SNMPv3 Access Table
- Configuring the SNMPv3 SecurityToGroup Table
- Configuring the SNMPv3 Notify Table
- Configuring the SNMPv3 Target Address Table
- Configuring the SNMPv3 Target Parameters Table
- Configuring the SNMPv3 Community Table
- Displaying the SNMPv3 Tables
- Displaying the User Table Entries
- Displaying the View Table Entries
- Displaying the Access Table Entries
- Displaying the SecurityToGroup Table Entries
- Displaying the Notify Table Entries
- Displaying the Target Address Table Entries
- Displaying the Target Parameters Table Entries
- Displaying the SNMPv3 Community Table Entries
- Section IV
- Spanning Tree Protocols
- Chapter 12
- Spanning Tree and Rapid Spanning Tree Protocols
- Section V
- Virtual LANs
- Chapter 13
- Port-based and Tagged VLANs
- Section VI
- Port Security
- Chapter 14
- 802.1x Port-based Network Access Control
- Index
Chapter 12: Spanning Tree and Rapid Spanning Tree Protocols
200 Section IV: Spanning Tree Protocols
Configuring the
RSTP Port
Settings
To configure the RSTP port parameters:
1. Perform steps 1 to 4 in “Configuring the RSTP Bridge Settings” on
page 196 to display the Spanning Tree tab.
2. Use the Stack ID pull-down menu in the switch image to select the ID
number of the switch you want to configure and click the Apply button.
You can configure only one switch at a time.
3. In the switch image click the port you want to configure. A selected
port turns white. To deselect a port, click it again. You can configure
more than one port at a time.
4. Click the Modify button to display the RSTP Port Settings window in
Figure 77.
Figure 77. RSTP Port Settings Window
5. Configure the parameters as needed.
Table 36. RSTP Port Parameters
Parameter Definition
Port Priority Specifies the port priority. This parameter
is used as a tie breaker when two or more
ports are determined to have equal costs
to the root bridge. The range is 0 to 240 in
increments of 16. The default value is 8
(priority value 128). For a list of the
increments, refer to Table 33 on
page 191.