User Manual

AT-S63 Management Software Web Browser User’s Guide
Section I: Basic Operations 31
Default Gateway If the stack has more than one routing
interface, this field displays the IP address
of the next hop of the stack’s default
route. The stack uses the default route
when it receives a network packet for
routing, but cannot find a route for it in the
routing table. This field will contain 0.0.0.0
if no default route is defined on the stack.
If the only routing interface on the stack is
the local interface, this field displays the
default gateway address. This is the IP
address of a router interface on your
network. The stack uses this address as
the next hop to reaching a remote network
device when the stack’s local interface
and the remote device are on different
subnets. The default value is 0.0.0.0.
Table 3. IP Configuration Section of the General Tab
Parameter Definition