User Manual
Table Of Contents
- Contents
- Figures
- Tables
- Preface
- Section I
- Basic Operations
- Chapter 1
- Basic Switch Parameters
- Chapter 2
- Port Parameters
- Chapter 3
- SNMPv1 and SNMPv2c
- Chapter 4
- MAC Address Table
- Chapter 5
- Static Port Trunks
- Chapter 6
- Port Mirroring
- Section II
- Advanced Operations
- Chapter 7
- File System
- Chapter 8
- File Downloads and Uploads
- Chapter 9
- Event Logs and the Syslog Client
- Chapter 10
- IGMP Snooping
- Section III
- SNMPv3
- Chapter 11
- SNMPv3
- Configuring the SNMPv3 Protocol
- Enabling or Disabling SNMP Management
- Configuring the SNMPv3 User Table
- Configuring the SNMPv3 View Table
- Configuring the SNMPv3 Access Table
- Configuring the SNMPv3 SecurityToGroup Table
- Configuring the SNMPv3 Notify Table
- Configuring the SNMPv3 Target Address Table
- Configuring the SNMPv3 Target Parameters Table
- Configuring the SNMPv3 Community Table
- Displaying the SNMPv3 Tables
- Displaying the User Table Entries
- Displaying the View Table Entries
- Displaying the Access Table Entries
- Displaying the SecurityToGroup Table Entries
- Displaying the Notify Table Entries
- Displaying the Target Address Table Entries
- Displaying the Target Parameters Table Entries
- Displaying the SNMPv3 Community Table Entries
- Section IV
- Spanning Tree Protocols
- Chapter 12
- Spanning Tree and Rapid Spanning Tree Protocols
- Section V
- Virtual LANs
- Chapter 13
- Port-based and Tagged VLANs
- Section VI
- Port Security
- Chapter 14
- 802.1x Port-based Network Access Control
- Index
AT-S63 Management Software Web Browser User’s Guide
Section I: Basic Operations 41
Egress Unknown Unicast
Filter
Use this parameter to configure a port to
forward or discard unknown egress
unicast packets. The possible settings
are:
Enabled - The port discards unknown
egress unicast packets.
Disabled - The port forwards unknown
egress unicast packets. This is the default
setting.
Ingress Unknown Multicast
Filter
Use this parameter to configure a port to
forward or discard unknown ingress
multicast packets. Possible settings are:
Enabled - The port discards unknown
ingress multicast packets.
Disabled - The port forwards unknown
ingress multicast packets. This is the
default setting.
Egress Unknown Multicast
Filter
Use this parameter to configure a port to
forward or discard unknown egress
multicast packets. Possible settings are:
Enabled - The port discards unknown
egress multicast packets.
Disabled - The port forwards unknown
egress multicast packets. This is the
default setting.
Flow Control Sets flow control on a port. This option
only applies to ports operating in full-
duplex mode. A switch port uses flow
control to control the flow of ingress
packets. The switch sends a special
pause packet to stop the end node from
sending frames. The pause packet
notifies the end node to stop transmitting
for a specified period of time. Possible
settings are:
Disabled - No flow control on the port.
This is the default.
Enabled - Flow control is activated.
Table 5. Port Configuration Window
Parameter Definition