User Manual

AT-S63 Management Software Web Browser User’s Guide
Section I: Basic Features 85
Modifying the Port Mirror
To modify the port mirror:
1. From the home page, click the Configuration button.
2. From the Configuration menu, click the Layer 1 button.
3. Click the Port Mirroring tab, shown in Figure 23 on page 81.
4. Click the Modify button to display the Modify Mirror popup window in
Figure 24 on page 82.
5. Click the Enable Mirror checkbox to remove the check and click the
Apply button.
Note
You should disable the port mirror before modifying it.
6. To add or remove source ports:
a. Click the Modify button.
b. Using the stack ID pull-down menu in the switch image, select the
ID number of a switch that has a port you want to remove as a
source port or add as a source port. If the switch is already
displayed, you can skip this step.
c. Click the port until it displays the desired setting, listed in Table 13
on page 83.
d. Click Apply to close the Modify Mirror popup window.
e. Repeat this step to add or remove other source ports.
7. To change the destination port, you must first deselect the current
destination port before designating the new port. To change the
destination port:
a. Click the Modify button.
b. Using the stack ID pull-down menu in the upper left corner of the
switch image, select the ID number of the switch that has the
current destination port. If the switch is already displayed, you can
skip this step.
c. Click the destination port to change it to one of the other settings in
Table 13 on page 83.