Manual

Chapter 9: Configuring the Wireless Settings
100
Configuring the Radio Interface
The radio interface allows you to set the radio channel and 802.11 mode
for each radio.
To configure the radio interface, perform the following procedure:
1. From the main menu, select Advanced > Wireless Settings.
The Wireless Settings page is shown in Figure 31 on page 98.
2. In the Radio Interface sections one and two, configure the following
settings:
Mode
The Mode defines the Physical Layer (PHY) standard being used by
the radio.
The AT-WA7400 Wireless Access Point is available as a single or dual
band access point with one or two radios. The configuration options for
Mode differ depending on which product you have.
Single-Band Access Point - For the single-band access point, select
one of these modes:
 IEEE 802.11b
 IEEE 802.11g
 Atheros Turbo 2.4 GHz
 Atheros Dynamic Turbo 2.4 GHz
Dual-Band Access Point - For the dual band access point, select one
of these modes for each Radio Interface.
 IEEE 802.11b
 IEEE 802.11g
 IEEE 802.11a
 Atheros Turbo 5 GHz (IEEE 802.11a Turbo)
Wireless Network Name (SSID)
The name for all wireless access points on this network. You cannot
change this name on this page. To change this name, refer to
“Configuring the Basic Settings and Starting the Wireless Network” on
page 37.
Channel
Select the Channel. The range of channels and the default is
determined by the Mode of the radio interface.