Manual

Chapter 10: Configuring Security
122
Figure 37. IEEE 802.1x Security Mode Settings
1. Configure the following settings:
Authentication Server
Select one of the following from the list:
Built-in - To use the authentication server provided with the
AT-WA7400 Wireless Access Point. If you choose this option, you do
not need to provide the Radius IP and Radius Key; they are
automatically provided.
External - To use an external authentication server. If you choose this
option you must supply a Radius IP and Radius Key of the server you
want to use.
Note
The RADIUS server is identified by its IP address and UDP port
numbers for the different services it provides. With firmware version
1.0 and greater, the RADIUS server User Datagram Protocol (UDP)
ports used by the access point are configurable. (The AT-WA7400
Management Software defaults to use RADIUS server UDP port
1812 for authentication and port 1813 for accounting.)
RADIUS IP
The Radius IP is the IP address of the RADIUS server.
(The IP address of the AT-WA7400 Wireless Access Point’s internal
authentication server is
127.0.0.1.)
If you have an external RADIUS server on your network, Allied Telesyn
recommends that you use it rather than the using the embedded
RADIUS server on the access point. An external RADIUS server will
provide better security than the local authentication server.