Manual

Chapter 12: VLANs
140
Configuring VLANs
Note
To configure additional networks on VLANs, you must first enable
virtual wireless networks on the Ethernet (wired) interface. See
“Enabling or Disabling Virtual Wireless Networks on the Access
Point” on page 90.
Caution
If you configure VLANs, you may lose connectivity to the access
point. First, be sure to verify that the switch and DHCP server you
are using can support VLANs per the IEEE 802.1Q standard. After
configuring VLANs, physically reconnect the Ethernet cable on the
switch to the tagged packet (VLAN) port. Then, reconnect using the
web pages to the new IP address. (If necessary, check with the
infrastructure support administrator regarding the VLAN and DHCP
configurations.)
To configure a VLAN, perform the following procedure:
1. From the main menu, select Advanced > Virtual Wireless Networks.
The Virtual Wireless Networks page is shown in Figure 43.
Figure 43. Virtual Wireless Networks Page
2. Configure the following settings as necessary: