Manual

AT-WA7400 Management Software User’s Guide
285
AT-WA7400# get cluster location
not set
Set the Location for an Access Point
To set the location for an access point, use the set command as follows:
AT-WA7400# set system location hallway
AT-WA7400# set system location "Vicky's Office"
To check to make sure that the location was set properly, use the get
command again to find out the location
AT-WA7400# get system location
Vicky’s Office
Get the Current Password
AT-WA7400# get system encrypted-password
2yn.4fvaTgedM
Set the Password
AT-WA7400# set system password admin
AT-WA7400# get system encrypted-password
/rYSvxS4Okptc
Get the Wireless Network Name (SSID)
AT-WA7400# get interface wlan0 ssid
Internal AT-WA7400 Network
Set the Wireless Network Name (SSID)
AT-WA7400# set interface wlan0 ssid "Vicky’s AP"
AT-WA7400#
get interface wlan0 ssid
Vicky’s AP
Access Point and
Cluster Settings
The command examples in this section show how to get the configuration
for a cluster of access points. These settings generally correspond to
those on the Cluster > Access Points page in the web UI.
Table 6 provides a quick view of Access Point Cluster commands and