Manual

AT-WA7400 Management Software User’s Guide
293
Note
You can get specifics on the guest interface by using the same types
of commands as for the internal interface but substituting
brguest
for
wlan0 . For example, to get the MAC address for the guest
interface: get interface wlan0 ssid
Get Current Wireless (Radio) Settings
The following examples show how to use the CLI to get wireless radio
settings on an access point, such as mode, channel, and so on. You can
see by the output results of the commands that the access point mode is
set to IEEE 802.11g, the channel is set to 6, the beacon interval is 100,
and so forth.
For information on how to configure radio settings through the CLI, see
“Radio Settings” on page 326.
(Radio settings are fully described in the web UI topic on “Configuring
Radio Settings” on page 147.)
Get the Current IEEE 802.11 Radio Mode
AT-WA7400#
get radio wlan0 mode
g
Get the Channel the Access Point is Currently Using
AT-WA7400#
get radio wlan0 channel
2
Get Basic Radio Settings for the Internal Interface
AT-WA7400#
get radio wlan0
Field Value
------------------------------
status up
max-bsses 2
channel-policy best
channel 6
static-channel 9
mode g
fragmentation-threshold 2346