Manual

Appendix D: Command Line Interface (CLI) for Access Point Configuration
302
Get Summary View of Internal and Guest Interfaces
Get the DNS Name
AT-WA7400# get host id
AT-WA7400-AP
Set the DNS Name
AT-WA7400# set host id vicky-ap
bob# get host name
vicky-ap
Get Wired Internal Interface Settings
See “Get Current Settings for the Ethernet (Wired) Internal Interface” on
page 291 under Displaying Status.
Get Wired Guest Interface Settings
See “Get Current Settings for the Ethernet (Wired) Guest Interface” on
page 292 under Displaying Status.
Get Current Settings for the Ethernet (Wired) Internal
Interface
get interface br0
Find out if guest access is enabled and configured.)
get interface brguest status
(will be “up” or “down”)
Set DNS Nameservers to Use Static IP Addresses (Dynamic
to Manual Mode)
See example below.
Set DNS Nameservers to Use DHCP IP Addressing (Manual
to Dynamic Mode)
See example below.
Table 9. Wired Interface Commands (Continued)
Function Command
AT-WA7400# get bss
name status radio beacon-interface mac
--------------------------------------------------------------------
wlan0bssInternal up wlan0 wlan0
00:0C:41:16:DF:A6