Manual

Appendix D: Command Line Interface (CLI) for Access Point Configuration
330
how you would use the CLI to set each one are shown in Table 27.
The following command sets the wireless mode to IEEE 802.11g:
AT-WA7400# set radio wlan0 mode g
Enable or Disable Super AG
You cannot enable/disable Super AG from the CLI. You must set this from
the web UI. For information on how to set this option, please see the field
description for this option in “Configuring Radio Settings” on page 147.
Set the Radio Channel
The following command sets the Channel to 6:
AT-WA7400# set radio wlan0 channel 6
Set the Beacon Interval
The following command sets the beacon interval to 80.
AT-WA7400# set radio wlan0 beacon-interval 80
Set the DTIM Period
The Delivery Traffic Information Map (DTIM) period indicates how often
wireless clients should check to see if they have buffered data on the
access point awaiting pickup. The measurement is in beacons. Specify a
DTIM period within a range of 1 - 255 beacons. For example, if you set this
to “1,” clients will check for buffered data on the access point at every
beacon. If you set this to “2,” clients will check on every other beacon.
The following command sets the DTIM interval to 3.
Table 27. Radio Mode Commands
Function Command
IEEE 802.11b
set radio wlan0 mode b
IEEE 802.11g
set radio wlan0 mode g
IEEE 802.11a
set radio wlan0 mode a
Atheros Turbo 5 GHz
set radio wlan0 mode turbo-a
Atheros Dynamic Turbo 5 GHz
set radio wlan0 mode dynamic-
turbo-a
Atheros Turbo 2.4 GHz
set radio wlan0 mode turbo-g
Atheros Dynamic Turbo 2.4 GHz
set radio wlan0 mode dynamic-
turbo-g