Manual

AT-WA7400 Management Software User’s Guide

333

5.5

Note

You can use the get command to view current rate sets from the

CLI as described in “Get Supported Rate Set” on page 328 and “Get

Basic Rate Set” on page 329. However, you cannot reconfigure

Supported Rate Sets or Basic Rate Sets from the CLI. You must use

the Advanced > Radio page on the web UI to configure this feature.

MAC Filtering

Note

Before configuring this feature, make sure you are familiar with the

names of the interfaces as described in “Understanding Interfaces

as Presented in the CLI” on page 278. The interface name you

reference in a command determines whether a setting applies to a

wired or wireless interface, the internal or guest network, or (on a

two-radio access point) to radio one or radio two.

You can control access to AT-WA7400 Wireless Access Point based on

media access control (MAC) addresses. Based on how you set the filter,

you can allow only client stations with a listed MAC address or prevent

access to the stations listed.

Specify an Accept or Deny List

To set up MAC filtering you first need to specify which type of list you want