Manual

AT-WA7400 Management Software User’s Guide
335
Getting Current MAC Filtering Settings
Get the Type of MAC Filtering List Currently Set (Accept or Deny)
The following command shows which type of MAC filtering list is currently
configured:
AT-WA7400# get bss wlan0bssInternal mac-acl-mode
accept-list
Get MAC Filtering List
The following command shows the clients on the MAC filtering list:
AT-WA7400# get mac-acl
name mac
-----------------------------------
wlan0bssInternal 00:01:02:03:04:05
wlan0bssInternal 00:01:02:03:04:06
wlan0bssInternal 00:01:02:03:04:07
wlan0bssInternal 00:01:02:03:04:08
Load Balancing
Note
Before configuring this feature, make sure you are familiar with the
names of the interfaces as described in “Understanding Interfaces
as Presented in the CLI” on page 278. The interface name you
reference in a command determines whether a setting applies to a
wired or wireless interface, the internal or guest network, or (on a
two-radio access point) to radio one or radio two.
Load balancing parameters affect the distribution of wireless client
connections across multiple access points. Using load balancing, you can
prevent scenarios where a single access point in your network shows
performance degradation because it is handling a disproportionate share
of the wireless traffic. (For a detailed conceptual overview of Load
Balancing, see Chapter 14, “Load Balancing” on page 155.)
The access point provides default settings for load balancing.
The following command examples reconfigure some load balancing
settings and get details on the configuration:
AT-WA7400# set radio wlan0 load-balance-disassociation-stations 2