Manual

Appendix D: Command Line Interface (CLI) for Access Point Configuration
336
AT-WA7400# get radio wlan0 load-balance-disassociation-stations
2
AT-WA7400#
set radio wlan0 load-balance-disassociation-
utilization 25
AT-WA7400#
AT-WA7400#
get radio wlan0 load-balance-disassociation-
utilization
25
AT-WA7400#
set radio wlan0 load-balance-no-association-
utilization 50
AT-WA7400#
AT-WA7400#
get radio wlan0 load-balance-no-association-
utilization
50
Quality of Service
Note
Before configuring this feature from the CLI, make sure you are
familiar with the names of the interfaces as described in
“Understanding Interfaces as Presented in the CLI” on page 278.
The interface name referenced in a command determines if a setting
applies to a wired or wireless interface, the internal or guest
network, or (on a two-radio access point) to radio one or radio two.
Quality of Service (QoS) provides you with the ability to specify
parameters on multiple queues for increased throughput and better
performance of differentiated wireless traffic like Voice-over-IP (VoIP),
other types of audio, video, and streaming media as well as traditional IP
data over the AT-WA7400 Wireless Access Point.
For a complete conceptual overview of QoS, see “Understanding QoS” on
page 162.