Manual

AT-WA7400 Management Software User’s Guide
39
If you choose “are ignored,” new access points will not join the cluster;
they will be considered standalone. You need to configure standalone
access points manually using KickStart and the AT-WA7400
management software residing on the standalone access points. (To
get to the web page for a standalone access point, use its IP address
in a URL as follows: http
: // IPAddressOfAccessPoint .)
Note
If you change the policy so that new access points “are ignored,”
then any new access points you add to the network will not join the
cluster. Existing clustered access points will not be aware of these
standalone access points. Therefore, if you are viewing the AT-
WA7400 management software web pages through the IP address
of a clustered access point, the new standalone access points will
not show up in the list of access points on the Cluster > Access
Points page. The only way to see a standalone access point is to
browse to it directly by using its IP address in the URL.
If you later change the policy to cluster so that new access points “are
configured automatically,” all subsequent new access points will
automatically join the cluster. Standalone access points, however, will
stay in standalone mode until you explicitly add them to the cluster.
For information on how to add standalone access points to the cluster,
see “Adding an Access Point to a Cluster” on page 50
4. In the Settings section, click Update to apply these settings and deploy
the access point as a wireless network.