Manual

Chapter 2: Setting up the AT-WA7400 Management Software
40
A summary of the settings is shown in Figure 15.
Figure 15. Summary of Settings Page
At initial startup, no security is in place on the access point. An
important next step is to configure security, as described in Chapter
10, “Configuring Security” on page 105.
At this point, if you click Basic Settings again, the summary of settings
page is replaced by the standard Basic Settings configuration options.
If you chose to ignore new access points, then as you add new access
points they will run in standalone mode. In standalone mode, an
access point does not share the cluster configuration with other
access points; it must be configured manually.
You can always update the settings on a standalone access point to
have it join the cluster. You can also remove an access point from a
cluster thereby switching it to run in standalone mode.
5. Click Update to activate the wireless network with these new settings.
Default
Configuration
If you follow the steps above and accept all the defaults, the access point
will have the default configuration described in Appendix A, “Management
Software Default Settings” on page 215.