Manual

AT-WA7400 Management Software User’s Guide
49
A MAC address is a permanent, unique hardware address for any
device that represents an interface to the network. The MAC address
is assigned by the manufacturer. You cannot change the MAC
address. It is provided here for informational purposes as a unique
identifier for the access point.
The address shown here is the MAC address for the bridge (
br0). This
is the address by which the access point is known externally to other
networks.
IP Address
The IP address of the access point. Each IP address is a link to the
AT-WA7400 Management Software web pages for that access point.
You can use the links to navigate to the web pages for a specific
access point. This is useful for viewing data on a specific access point
to make sure a cluster member is picking up cluster configuration
changes, to configure advanced settings on a particular access point,
or to switch a standalone access point to cluster mode.To see MAC
addresses for guest and internal interfaces on the access point, see
the Status > Interfaces page.
Modifying the
Location
Description
To change the location description for an access point:
1. From the main menu, select Basic Settings.
The Basic Settings page is shown in Figure 13 on page 35.
2. Update the Location description in section 1 under “Review
Description of this Access Point.”
3. Click Update to apply the changes.
Removing an
Access Point from
the Cluster
To remove an access point from the cluster, do the following.
1. From the main menu, select Cluster > Access Point.
The Access Points page is shown in Figure 17 on page 48.
2. Click the checkbox next to the access point so that the box is checked.
3. Click Remove.
The change is under Status for that access point; the access point will
now show as standalone (instead of cluster).