Manual

AT-WA7400 Management Software User’s Guide
55
MAC Filtering of Rogue Access Points
When an access point is not listed in the access points list, the MAC
filtering of rogue access points feature sends an SNMP trap to alert you to
the unregistered (rogue) access point.
To enable MAC filtering of rogue access points, perform the following
procedure:
1. From the main menu, select Advanced > Pre-Config Rogue AP.
The Configure MAC Filtering of Rogue Access Points page is shown in
Figure 20.
Figure 20. Configure Rogue MAC Filtering of Access Point Page
2. To add an access point to the list:
a. Type its MAC address in the fields above the Add button.
b. Click Add.
c. Click Update.
3. To remove an access point from the list:
a. Select the MAC address of the access point in the Access Points
List.