Manual

AT-WA7400 Management Software User’s Guide
93
Configuring the Internal Interface Ethernet Settings
To configure Ethernet (wired) settings for the internal LAN, perform the
following procedure:
1. From the main menu, select Advanced > Ethernet (Wired) Settings.
The Ethernet (Wired) Settings page is shown in Figure 30 on page 88.
2. In the Internal Interface Settings section, configure the following
settings:
MAC Address
Shows the MAC address for the internal interface for the Ethernet port
on this access point. This is a read-only field that you cannot change.
VLAN ID
If you choose to configure internal and guest networks by VLANs, this
field is enabled. Enter a number between 1 and 4094 for the internal
VLAN.
This causes the access point to send DHCP requests with the VLAN
tag. The switch and the DHCP server must support VLAN IEEE
802.1Q frames. The access point must be able to reach the DHCP
server.
Check with the Administrator regarding the VLAN and DHCP
configurations.
PHY Type
The speed and duplex settings for the LAN (Ethernet) port. The
options are:
Auto -The speed and duplex are automatically selected.
(recommended)
10Mbps Full - 10Mbps and full duplex.
10Mbps Half - 10Mbps and half duplex.
100Mbps Full - 100Mbps and full duplex.
100Mbps Half - 100Mbps and half duplex.
Secure Management
This selection enables or disables the Management IP Address field:
Enabled - Only the client with the IP address specified in the next
selection can manage the access point.
Disabled - Even if an IP address for a wireless client is specified, no
client can manage the AP.
Management IP Address
The IP address of a wireless client that can manage the access point.
Deny Management via WLAN
If checked, disables management access to the access point by a