AT-6102 IEEE 802.
Electrical Safety and Emissions Standards Standards: This product meets the following standards. U.S. Federal Communications Commission This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation.
Contents Electrical Safety and Emissions Standards...................................................................................2 Safety and Electromagnetic Emissions Certifications ..............................................................2 Contents ......................................................................................................................................3 Figures.............................................................................................................
Preface Purpose of This Guide This guide is intended for network administrators who are responsible for installing and maintaining the AT-6102 IEEE 802.3af PoE Splitter. How This Guide is organized This guide contains the following chapters and appendices: Chapter 1 Introduction: describes the features, functions, LEDs, and ports on the equipment. Chapter 2 Installation: describes how to install the equipment. Specifications: provides equipment specifications.
Contacting Allied Telesis This section provides Allied Telesis contact information for technical support as well as sales and corporate information. Online Support You can request technical support online by accessing the Allied Telesis Knowledge Base: http://www.alliedtelesis.com/kb/. You can use the Knowledge Base to submit questions to our technical support staff and review answers to previously asked questions.
Chapter 1 Introduction Thank you for purchasing the AT-6102 IEEE 802.3af PoE Splitter. The Power over Ethernet Splitter allows a network device that is not POE capable to be remotely powered through an 802.3af compliant line. The following figure shows how Power over Ethernet Splitter works. Non PoE devices AT-6102 AT-6101 Figure 1: AT-6102 typical application Features • • • • • • • • • • • • • IEEE802.3af compliant Short circuit protection Delivering power and data to equipment 5V, 7.
• • Power Out port: It supports two types of power cable – Inner dimension 5.5 x 2.0mm, length 360 mm and 5.5 x 2.5 mm, length 360mm. Both cables are included in the POE Splitter package. The Power Out port is capable of feeding 5V, 7.5V, 9V or 12V DC power to the device. LED indicator: one Power LED indicator for the system unit.
Chapter 2 Installation To install the Power over Ethernet Splitter, please follow the following steps in this exact order: 1. Select on the POE Splitter an output Voltage compatible with the device to be powered. Be aware that Voltage DIP switch is factory set on 5V. When you change voltage by DIP switching to different voltage, the Power over Ethernet Splitter must be in power off status. 2.
