User's Manual
Table Of Contents
- Contents
- Figures
- Preface
- Chapter 1
- AlliedWare Plus™ Version 2.1.2 Web Browser Interface
- Chapter 2
- Starting a Management Session
- Chapter 3
- Basic Switch Parameters
- Setting the System Date and Time
- Setting a Telnet or SSH Server
- Setting a Remote Log Server
- Setting the Switch Information
- Setting the Configuration File
- Managing User Accounts
- Rebooting a Switch
- Upgrading the Software
- Returning the AlliedWare Plus Management Software to the Factory Default Values
- Displaying System Information
- Chapter 4
- Setting Port Parameters
- Chapter 5
- Setting Port Statistics
- Chapter 6
- Setting Port Mirroring
- Chapter 7
- Setting the Port Spanning Tree Protocol
- Chapter 8
- Setting the MAC Address
- Chapter 9
- Setting LACP
- Chapter 10
- Setting Static Port Trunks
- Chapter 11
- Setting Port-based and Tagged VLANs
- Chapter 12
- Setting Switch Spanning Tree Protocols
- Chapter 13
- Setting Internet Group Management Protocol (IGMP) Snooping
- Chapter 14
- Setting MAC Address-based Port Security
- Chapter 15
- Setting RADIUS and TACACS+ Clients
- Chapter 16
- Setting 802.1x Port-based Network Access
- Chapter 17
- Setting IPv4 and IPv6 Management
- Chapter 18
- Setting LLDP and LLDP-MED
- Chapter 19
- Setting sFlow
AlliedWare Plus Version 2.1.2 Management Software Web Browser User’s Guide
51
Upgrading the Software
You can obtain the latest version of the AlliedWare Plus software from the
Allied Telesis web site. You must have access to a TFTP server from your
PC to upgrade the AlliedWare Plus software on your switch. Allied Telesis
does not include this application with the software. The upgrade process
takes approximately three minutes.
Upgrading the system software on the switch ends your current web
browser management session. To continue managing the switch, you
must login again.
Note
All unsaved changes are discarded when you upgrade the software
on a switch. To save your changes, click SAVE.
To upgrade the AlliedWare Plus software, perform the following
procedure:
1. Open your TFTP server software and provide it with the IP address of
the your PC.
2. Select the System Tab.
The System Settings Tab is displayed. See Figure 6 on page 33.
3. From the System Settings tab, select Dashboard.
The Dashboard Page is displayed. See Figure 4 on page 23.
4. Select System Upgrade
at the bottom of the page.
The System Upgrade page is displayed. See Figure 18 on page 52.