User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
Chapter 2: Optional Antennas and Cables
24
Optional Antennas
The AT-TQ4400e access point is shipped with a set of antennas. In
addition to the antennas, you may use the following optional antennas:
”AT-AN2458-10DP Mini Panel Antenna”
“AT-AN5158-16DP Sector Antenna” on page 26
“AT-AN5158-19DP Flat Panel Antenna” on page 28
Note
For how to install the optional antennas, see Chapter 4, “Installing
the Optional Antennas” on page 55.
AT-AN2458-
10DP Mini Panel
Antenna
The AT-AN2458-10DP Mini Panel Antenna features two independent
dual-band, vertically and horizontally polarized antennas in a single
housing. The housing has drain holes to help prevent moisture build-up
inside the antenna. See Figure 4.
Figure 4. AT-AN2458-10DP Mini Panel Antenna
The Antenna is supplied with a mast mount kit. It allows the antenna to be
mounted to a 1 inch (25.4 mm) to 1.7” (43.2 mm) diameter mast and
adjusted upward or downward up to 30°.
Features
All weather operations
Dual polarity feed system in single enclosure
MIMO: Multiple Input and Multiple Output
Draft 4 on November 9, 2017