User's Manual

Chapter 3: Installing the Access Point
50
2. Change the IP address on your management PC to 192.168.1.n.
The n is any number from 1 to 254, except 230. Refer to the
documentation that accompanies your PC for instructions on how to
set the IP address.
3. Set the subnet mask on your management PC to 255.255.255.0.
4. Start the web browser on your management PC.
5. Enter the IP address 192.168.1.230 in the URL field of the browser.
The logon window appears as shown in Figure 22.
.
Figure 22. Logon Window
6. Enter “manager” for the username and “friend” for the password.
The username and password are case-sensitive.
Starting the
Initial
Management
Session with a
DHCP Server
This procedure explains how to start the initial management session on
the access point when the LAN port is connected to a network that has a
DHCP server. This procedure assumes that you have already configured
the DHCP server to assign the access point all the necessary
configuration information (for example, IP address and default gateway)
for your network.
To start the management session, perform the following procedure:
1. Connect the access point to a PoE switch.
2. Start the web browser on your management PC.
3. Enter the IP address of the access point in the URL field of the
browser.
Note
Use the IP address assigned to the access point by the DHCP
server. If you do not know the address, refer to the DHCP server.
Draft 4 on November 9, 2017