User's Manual
Table Of Contents
- Contents
- Preface
- Chapter 1
- Chapter 2
- Chapter 3
- Installing the Access Point
- Reviewing Safety Precautions
- Unpacking the AT-TQ4400e Access Point
- Optional Antennas
- Attaching the Ground Cable to the Access Point
- Connecting the Access Point with the Ethernet Cable
- Installing the Access Point on a Wall
- Installing the Access Point on a Pole
- Attaching the Antennas to the Access Point
- Starting the Initial Management Session on the Access Point
- Setting the Country Setting
- Installing the Access Point
- Chapter 4
- Appendix A
- Appendix B
AT-TQ4400e Outdoor Wireless Access Point Installation Guide
59
Installing the AT-AN5158-16DP Sector Antenna
To install the AT-AN5158-16DP Sector Antenna, perform the following
procedure:
1. Find an adequate place to install the antenna.
2. Install the mounting hardware attached to the antenna onto the pole as
shown in Figure 28.
Figure 28. Installing Sector Antenna to the Pole
3. Connect cables to the connectors on the back panel of the antenna as
shown in Figure 29.
Figure 29. Installing Antennas to the Access Point
Draft 4 on November 9, 2017